[Wash & Cure Station] Cure Station: Replacing the Mainboard/ Touch Panel

When the mainboard or touch panel of your Cure Station malfunctions, replacing it is crucial to restore full functionality. In this article, we’ll walk you through a detailed, step-by-step guide on how to replace the mainboard or touch panel, ensuring that your device operates smoothly and efficiently once again.

1. Removing the Old Mainboard

Power down and prepare

• Switch off the device.
• Unplug the power cord from the device.
• Use the H2.5 hex key to loosen 9 screws and remove the bottom case.

• Remove and keep the bottom case aside.

Removing the old mainboard/touch panel

• Disconnect all the cables connecting to the old mainboard.

• Loosen the 4 screws securing the old mainboard in place.

• Removing the old mainboard from the Cure Station.

2. Installing the New Mainboard

Installing the new mainboard/touch panel

• Place the new mainboard in its designated position.
• Tighten the 4 screws to secure the new mainboard in place.
• Connect all the cables to their corresponding ports on the new mainboard.

Verifying the new mainboard’s functionality

• Plug in the power cord and switch on the Cure Station.
• Check if the device works normally.

Contact Support

By following the above instructions, you can easily replace the mainboard of your Cure Station. If you face any difficulties during the troubleshooting process, feel free to reach out to Phrozen Support or your Authorized Resellers for further assistance. When contacting Phrozen Support, kindly send some photos or videos illustrating the issue.