[Cure Mega S] Checking the Sensor Cable

There is an issue with the sensor of your Cure Mega S? Before seeking external assistance or deciding to replace any spare parts, you can make an attempt at checking the sensor. This article will guide you through simple steps to verify the sensor cable connection.

1. Checking the Sensor Connection

Power down and Prepare

• Turn off the curing unit and unplug the power cord
• Gently lay down the unit
• Use an Allen Wrench (size 2.5) to loosen the 10 screws and open the bottom case

Reconnect the sensor cable

• Locate the sensor cable connecting to the mainboard

• Reconnect the sensor cable

Reassemble the device and Verify the sensor functionality

• Tighten the 10 screws to reinstall the bottom case
• Insert the power cord and power on the curing unit
• Close the door of the curing unit
• Check if the curing unit can work normally

Contact Support

By following the above steps, you can easily reconnect the sensor cable of your Cure Mega S. If you find any issues, feel free to reach out to Phrozen Support or your Authorized Reseller for further assistance. When contacting Phrozen Support, kindly send some photos or videos illustrating the issue.