[Sonic Mini 8K] First print with Phrozen test file

After correctly calibrating your Z-axis, it’s time for you to test out your first print with the Sonic Mini 8K! We have included a test file in the USB drive for you to test out the LCD 3D printer with Aqua-Gray 8K resin.

Step 1: Suiting Up

As direct contact with resin may cause allergic reactions, it is advisable to wear PPE (Personal Protective Equipment) masks, goggles, and gloves while printing.

Step 2: Install the Resin Vat

Install the resin vat. Please make sure that the bottom screws of the resin vat are perfectly aligned with the platform grooves. Then tighten the screws on both sides.

Please pay attention to the bottom screws and DO NOT damage the LCD screen when placing the resin vat.

Step 3: Fill the Vat with Resin

Make sure to shake the resin well (for approximately 1 min.) before pouring it into the resin vat. When pouring resin, make sure it does not exceed the max fill line on the resin vat.

Step 4: Transfer your File to Sonic Mini 8K

Please note that the Sonic Mini 8K 3D printer only offers a USB data transfer method. Please save the file as a .CTB file as the Sonic Mini 8K can only read .CTB files. Plug in your USB into the USB portal of Sonic Mini 8K to begin printing.

Step 5: Start Printing

On the touch panel, click PRINT, and select your .CTB file. The printing process will take approximately 2 hours.

*Note: Prior to each print session, check to see if the resin vat has already been filled with resin. Please use the plastic scraper included in the toolbox to search for cured resin left in the vat. Use the scraper to stir the resin.

Inspect the platform of the machine and check to see if any clutter has been left behind. Remove the clutter and you can begin printing.

Step 6: Finish Printing

Once the printing process is complete, the building plate will retract to the top. Wait until the resin has drained completely before proceeding onto the next step: post-processing.