[Wash Mega S] Preventing Alcohol Leakage

Preventing alcohol leakage from your bucket is essential for maintaining the integrity of your post processing process. By following these simple steps to remove, install, and tighten the faucet, hexagonal bush and spacer, you can ensure a secure and leak-free setup.

Reinstalling the Faucet, Hexagonal Bush and Spacer

• The first step in preventing alcohol leakage from your bucket is to remove the faucet and the spacer. Use a wrench to carefully unscrew and detach these components from the bucket. Set them aside for later re-installation.
  
  
• Next, install the hexagonal bush onto the faucet. Ensure that it fits snugly and covers the entire circumference of the faucet. Tighten the hexagonal bush securely using a wrench to create a tight seal.
  
  
• Once the hexagonal bush is tightened onto the faucet, grab the spacer. Place the spacer on the inner side of the bucket, while positioning the faucet end with the hexagonal bush on the outer side of the bucket.
  
  
• Securely tighten the spacer onto the bucket using a wrench. Make sure it is well aligned with the hole in the bucket to prevent any potential leaks. Apply firm pressure to ensure a tight seal.
  
  
• After tightening both the hexagonal bush onto the faucet and the spacer onto the bucket, check for proper alignment and tightness. Ensure that the components are securely attached and that there are no gaps or loose fittings.

Your setup is now secure and ready to use for cleaning models. Enjoy peace of mind knowing that your equipment is leak-proof and reliable.

Contact Support

By following the above instruction, you can easily able to prevent alcohol leakage for your Wash Mega S. If you find any issues, feel free to reach out to Phrozen Support or your Authorized Reseller for further assistance. When contacting Phrozen Support, kindly send some photos or videos illustrating the issue.