[Sonic 4K 2022] Z軸校正

Z 軸校正對於每台 3D 列印機都是必不可少的。進行此測試以確保載台與 LCD 保持水平。這是為了確保模型有粘附在載台上。

第 1 步 : 取出樹脂槽並確保清除機器平台上存在的任何物體。

Step 2: Prepare a piece of A4 paper and lay it flat on the LCD. This piece of paper will be used for leveling the building plate.

Step 3: Use a wrench to loosen all 4 screws present on the sides of the building plate. After loosening it, make sure to double-check to see if the plate is loose and movable.

Step 4: Click on the Z CALIB button on your printer’s touch panel to begin the process. Wait for 1-2 minutes as the building platform extends to touch the A4 paper laying flat on the LCD.

Step 5: Once the plate has touched down, press down tightly on the sides of the building plate and adjust it to make sure it is lying tight against the sheet of paper.

Step 6: Tighten all 4 screws on the sides of the building plate, with the other hand still pressing the building plate down.

Step 7: Click DONE on the touch screen and wait for the building plate to retract.

Step 8: Once the plate has retracted, remove the A4 paper, and you’re ready to begin your 3D printing journey!