As the resin level drops, you will need to refill the resin vat (or resin tank) to ensure a successful print. The following are steps for adding resin mid-print:
- DO NOT pause the printing process.
- Remove/open the case/chamber.
- Slowly pour resin into the vat as the building plate moves up. Make sure the UV lights are turned off while doing so.
- Once the resin vat has been filled, place/close the case back onto your 3D printer. Resume printing.
DO NOT overfill the resin vat as this may cause spillage, which could damage your device.
After each print, use the yellow plastic scraper included in your toolbox to remove any cured resin left on the building plate and the FEP film. Learn how to remove cured resin on the FEP film here.